Polyvend ULTRA VENDOR 32, Service Manual

Page: 7 / 53

* Operate each dispenser, using coins. Operation should be smooth. Remember; the
safety interlock must be energized in order to test out the changer. To energize,
pull out the plunger on the safety interlock switch located at the back of the pull
out drawer (See figure 4 on page 10).
* Load the machine with product (See section on product loading).
* Place the price stickers on the trays to the right of the selection stickers. Set the
prices of the products (See price setting).
Note: To set the prices, the safety interlock switch must be energized by pulling
the plunger out located on the switch at the back of the pull out drawer.
* Check to make sure that the Vend Options: forced vend and changer mode; are at
the desired setting (See detailed control board operation).
SERVICE DOOR ADJUSTMENT SPEC.
1 / 1 6
l / 8 - -
FLUSH W/ BOTTOM
OF HOOD +-1/16
ATTFNTION
AT THE TIME OF MACHINE INSTALLATION1
1. LEVEL MACHINE BY ADJUSTING LEGS.
2. ONCE MACHINE IS LEVELED, IF THE
DOOR GAP IS OUT OF ADJUSTMENT, PROPER
DOOR TO CABINET ALIGNMENT (GAP) CAN
BE ACHIEVED BY:
A) OPEN DOOR 8 LOOSEN HINGE SCREWS.
B) POSITION DOOR UP OR DOWN TO ATTAIN
AN EVEN GAP (FACTORY SPEC. IS 1/8"
FROM BOTTOM OF HOOD ON CABINET TO
TOP OF DOOR.)
C) RE-TIGHTEN SCREWS IN TOP, MIDDLE 8
BOTTOM SEQUENCE.
4