Poldent Endostar Provider, Instructions For Use Manual, Page: 13 / 48

12 Instructions for Use 2019-03-20
Torque Setting
Memory Number
Rotation Mode
Battery Power
Speed Setting
OTR Torque Setting
Torque Reverse Setting
Current Torque
Operation Mode
Standby Display (OTR Mode)
Standby Display (Normal Mode)
Torque Display
1. Turn Endostar Provider On: Press the Main Switch.
The standby display will appear.
When the standby display is being shown, you can turn the device off by holding down the Select Switch and pressing the Main Switch
2. Select Memory Number: Press the Plus or Minus Switch.
* There are six memories for various combinations of speed, torque reverse and rotation mode settings.
* The backlight will temporarily change color if changing the memory number changes anything other than the speed, torque reverse,
and rotation mode settings.
3. Start Motor: Press the Main Switch again.
The torque display will appear.
* If you hold the Main Switch down when you start the motor, it will run only while the switch is held down and stop when the switch is
released.
* You can temporarily change the torque reverse setting while the motor is running by pressing the Plus or Minus Switch. (This works only
for normal mode.)
* The color of the backlight changes depending on the load applied to the file.
* The backlight starts blinking when the load approaches the reverse setting. While the OTR is triggered, the backlight does not blink.
4. Stop Motor: Press the Main Switch again.
The standby display will reappear.
5. Turn Endostar Provider Off: Hold the Select Switch and then press the Main Switch.
* The device turns itself off automatically if it is not used for 3 minutes (initial setting).
For meter readings and operation connected to the Endostar Navigator; p. 20“Meter Display”
(3) Operation
Main Switch
(Turn power on and starts/stops rotation)
Liquid Crystal Display
Select Switch
Plus and Minus Switches
(Select memory and change settings)
Basic Operation
• Be sure to check the new settings whenever you change the Memory Number.
• The temperature at the position 8 cm from the contra angle tip rises up to +48.3°C (+118.9°F) when the ambient temperature is +35°C (+95°F).
• When the OTR seems to be triggered too frequently, or it is triggered immediately after starting the normal rotation, increase the torque setting by one level.
When the Apical Torque Reduction is set to “ON”, the torque setting cannot be temporarily changed.