54
Replacing the M. Blade/M.S. Disk and Motor Disk Assemblies
•
Replace the M.S. Disk, attached to the M. Blade Assembly, in the Base Ring. Be sure
the pins of the Mode Select Levers are correctly inserted in their holes and that the
S. Set Cam shaft projects through its hole in the M.S. Disk (Figure 3-25).
Figure 3-25. M. blade assembly replacement
•
Secure the M.S. Disk to the Base Ring with four screws.
•
Secure the Mode Select Levers by replacing the E-Rings on the ends of the Lever
pins, at the front of Shutter.
•
On the S. Set Cam shaft (Figure 3-26), replace the Pin in the hole in the Shaft, then
push the Gear on the Shaft until the Pin seats in the recess on the underside of the
Gear. Secure the Gear with the Screw.
Summary of Contents for Miniportrait 455
