44
Removing the Shutter Assembly
•
Remove the Pack Film Holder Frame, Light Baffle, Bottom Cover, Lenses and Front
Panel (See Camera Body Disassembly).
•
Unplug connectors from CN1 and CN3 on the Main PC Board (Figure 3-13A).
•
Disconnect the brown and white wires from CN1 (press on terminal catch, through
opening in side of connector (Figure 3-13B).
•
From the X-Sync Connector (Figure 3-13C), unsolder the yellow wire from the shell
(lug terminal) and the white wire from the pin (center terminal). Pull wires through the
opening into Camera Body interior.
•
Remove the four pan head screws at the outermost corners of the Shutter Base Plate,
attaching the brass Shafts to the Shutter Assembly (Figure 3-13D).
•
Remove the four screws at the corners of the Base Plate, attaching the Shutter
Assembly to the Camera Body. Lift Shutter Assembly out of the Camera Body.
SUGGESTION: Reinsert screws in the parts from which they were removed.
Summary of Contents for Miniportrait 455
