46
Shutter Disassembly
This section explains how to remove the M. Blade and Diaphragm Blade Assemblies from
the back of the Shutter, after the Shutter Assembly has been removed from the Camera.
If further disassembly is required, or components on the front of the Shutter require
servicing, see Plates 8 - 13 in the 455 Parts Catalog.
Remove or disassemble parts by following the order of the circled numbers/letters on the
illustration referenced.
Removing the M. Blade Assembly as a unit
Note: This will gain access to the Diaphragm Blade Assembly.
•
Remove the Motor Disk with Motor attached, by removing the six mounting screws
(Figure 3-12).
•
Remove the Spring “a” between the Exposure Counter Lever “b” and the Pawl “c”
(Figure 3-14).
Figure 3-14. Disassembling exposure counter components
Summary of Contents for Miniportrait 455
