41
Electronic Flash Disassembly
Note: (With Flash Unit removed from Camera — see removal procedure in this
Section.
•
Remove parts in the sequence shown by the circled numbers on Figure 3-11.
•
In 3 , pry off the Diffuser by inserting a thin blade in the slot between the Diffuser and
the Front Case. Rotate the blade clockwise (See inset Figure 3-11).
•
In 5 , remove two screws from the Front Case, beneath the Left Cover (on Viewfinder
side).
•
In 8 , access to the two screws to be removed from the Front Case is through
openings in the Knob 7 , visible after removing the Knob Cover 6 .
CAUTION
IMMEDIATELY AFTER REMOVING FRONT CASE< DISCHARGE
SMALL CAPACITOR WITH DUMP PROBE.
•
To service the Reflector 9 or the Xenon Tube 10 , lift Knob 7 and pull it off.
The Left and Right Protectors 11 & 12 slip off the Reflector.
•
To service the PC Boards 13 & 14 , remove the PC Board Upper
Assembly 13 by removing its three mounting screws.
•
If further disassembly is required, refer to the exploded parts illustrations shown in
Figure 3-11.
Summary of Contents for Miniportrait 455
