6.12
BRAKES
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
NOTE: Step 9 is only necessary if more slack is
required for removal in Step 10 and Step 11.
9.
At caliper end of parking brake cable, have an
assistant push inner cable into the outer cable casing
as far as possible to maximize slack at the lever end.
10. Remove cable from lever arm.
11. Pull cable out of holder on frame.
Cable Installation
1.
On a new cable or if adjuster was loosened upon
removal, turn cable adjuster that is located on the
underside of the vehicle out until approximately 3/4
(20mm) of thread is exposed. Screw jam nut against
the adjuster nut. Hold adjuster and tighten jam nut
securely.
2.
Turn the cable adjuster located near the rear brake
caliper inwards until it is fully seated.
3.
Route cable to passenger side of shift cables and
through holder on park brake lever bracket.
4.
Pull inner cable and attach it to parking brake lever
arm.
5.
Refer to routing photos in the cable removal process
to route the cable along the frame rails and out the
right side, near swingarm pivot.
6.
Secure cable to frame with new tie straps.
7.
Carefully remove supports and lower the vehicle.
8.
Route cable through guide at front of swingarm and
back to rear caliper.
9.
Secure cable to swingarm with rear brake line.
10. Connect caliper end of the cable.
11. Adjust parking brake and inspect cable freeplay.
1. Hold
2. Push