Polaris DP-20, User Manual, Page: 29 / 66

DP-20 WEB GUIDE CONTROLLER USER MANUAL
6
6-7
10. If the contrast is not sufficient for guiding,
FAILED will be displayed on line 2. Press the
MANUAL key to exit the setup menus and
return to the Operator Level. Repeat this
procedure, as necessary.
06-05-2007 DP-20 WEB GUIDE CONTROLLER Figure Sheet 1-862-D
3X.1.4, Calibration, Servo-Center Sensor
(The default calibration for the Servo-Center Sensor should be sufficient,
but this procedure may be used, if necessary).
1. Press the SETUP key to enter the Setup
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
2. Press the ENTER key to enter the BASIC
Menus. The GAIN menu will be displayed.
3. Use the ARROW keys to scroll until
CALIBRATION is displayed on line 3.
4. Press the ENTER key to enter the
CALIBRATION menu. SELECT SENSOR will
be displayed on line 3.
5. Use the ARROW keys to select the Servo-
Center Sensor.
~ƒ
will be displayed on line 1
and (X2) will be displayed on line 4.
6. Press the ENTER key to begin the calibration.
UNCOVER SENSOR will be displayed on line
2. Position the flag such that it is located away
from the surface of the sensor (see graphic at
right). The sensor signal is displayed on Line 3
of the LCD Panel.
Sensor
Flag
7. Press the ENTER key. COVER SENSOR will
be displayed on line 2. Position the flag such
that it is positioned directly in front of the sensor
and is fully covering the sensor (see graphic at
right). The sensor signal is displayed on Line 3
of the LCD Panel.
Sensor
Flag
~ƒ 3F.1.4.2
UNCOVER SENSOR
-ÜÜÜÜÜÜÜÜÜÜ+ 0%
× 3A.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
× 3A.1.4
SETUP (MAN)
CALIBRATION
× 3A.1.4.1
SETUP (MAN)
SELECT SENSOR
(X5)
~ƒ 3F.1.4.1
SETUP (MAN)
SELECT SENSOR
(X2)
~ƒ 3F.1.4.3
COVER SENSOR
-ãããããããããá+ 95%
× 3A.1
SETUP (MAN)
SELECT MENU
BASIC
Ł 3E.1.4.6
FAILED
-áÜÜÜÜÜÜÜÜÜ+ 3%