Polaris DP-20, User Manual, Page: 25 / 66

DP-20 WEB GUIDE CONTROLLER USER MANUAL
6
6-3
5. Press the ENTER key to allow adjustment of
the Guide Polarity. The current Guide Polarity
setting will begin flashing on line 4.
6. Use the ARROW keys to change the
POLARITY to the desired setting as indicated
on Line 4.
7. Press the ENTER key to store the change or
press the MANUAL key to abort the change.
The system will exit the setup menus, and
return to the Operator Level.
× 3A.1.3.1
SETUP (MAN)
GUIDE POLARITY
-
× 3A.1.3.1
SETUP (MAN)
GUIDE POLARITY
+
3A
MANUAL
× -ãããããáÜÜÜÜ+
3X.1.4, Calibration, Edge Sensors
CAUTION: Do NOT preform calibration when using an SC-100 capacitance sensor with a DP-
20.
1. Press the SETUP key to enter the Setup
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
2. Press the ENTER key to enter the BASIC
Menus. The GAIN menu will be displayed.
3. Use the ARROW keys to scroll until
CALIBRATION is displayed on line 3.
4. Press the ENTER key to enter the
CALIBRATION menu. SELECT SENSOR will
be displayed on line 3. If Center Guiding was
the current sensor mode, the sensor mode is
forced to Edge Left (X5).
5. If necessary, use the ARROW keys to select
the desired sensor (Edge Left or Edge Right)
to
be calibrated. The associated sensor connector
is displayed on line 4.
6. Press the ENTER key to begin the calibration.
UNCOVER SENSOR will be displayed on line
2. Remove all materials from the sensor field of
view (see graphic at right). The sensor signal is
displayed on Line 3.
Web
Sensor
×Ø 3C.1
SETUP (MAN)
SELECT MENU
BASIC
×Ø 3C.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
×Ø 3C.1.4
SETUP (MAN)
CALIBRATION
× 3A.1.4.1
SETUP (MAN)
SELECT SENSOR
(X5)
Ø 3B.1.4.2
UNCOVER SENSOR
-ÜÜÜÜÜÜÜÜÜÜ+ 0%
Ø 3B.1.4.1
SETUP (MAN)
SELECT SENSOR
(X4)
06-05-2007 DP-20 WEB GUIDE CONTROLLER Figure Sheet 1-862-D