Polaris DP-20, User Manual, Page: 20 / 66

DP-20 WEB GUIDE CONTROLLER USER MANUAL
5
5-2
4. Use the ARROW keys to adjust the SC Guide
Point to the desired position as indicated on
line 4.
5. If desired, press both of the ARROW keys
simultaneously to reset the Servo-Center Guide
Point to 0.0% as indicated on line 4.
6. Press the ENTER key to store the change or
press the MANUAL key to abort the change.
The system will exit the setup menus, and
return to the Operator Level. The Servo-Center
Guide Point value will be displayed on Line 4 if
the value is not 0.
×Ø 2C.2.1
SETUP (SC)
~ƒ GUIDE POINT
-ÜÜåÜÜÜÜ+ -21.0%
×Ø 2C.2.1
SETUP (SC)
~ƒ GUIDE POINT
-ÜÜÜåÜÜÜ+ 0.0%
×Ø 2C
SERVO-CENTER
~ƒ -ããããÜÜÜÜÜÜ+
~ƒ GP: -21.0%
2X.3, Measurement
1. Press the SETUP key to enter the Setup
Menus. The SC GAIN menu will be displayed
on the LCD Panel.
2. Use the ARROW keys to scroll until
MEASUREMENT is displayed on line 3.
3. Press the ENTER key to view the
Measurement menus. The level of the guiding
signal from the Left Edge Sensor (Line Center
if a line sensor is being used) is displayed on
Line 4. This signal has been scaled by values
which were determined during the Sensor
Calibration procedure.
4. Use the ARROW keys to scroll to the desired
Measurement menu. Next in the list is the Right
Edge Sensor (Line Edge if a line sensor is
being used). The guiding signal is displayed on
Line 4. This signal has been scaled by values
which were determined during the Sensor
Calibration procedure.
×Ø 2C.1
SETUP (SC)
~ƒ GAIN
ãÜÜÜÜÜÜÜÜÜ 5.0%
×Ø 2C.3
SETUP (SC)
MEASUREMENT
×Ø 2C.3.1
MEASUREMENT
× SENSOR (X5)
-ããããÜÜÜÜ+ 50%
ý 2D.3.1
MEASUREMENT
ý SENSOR (X4)
-ããããÜÜÜÜ+ 50%
×Ø 2C.3.2
MEASUREMENT
Ø SENSOR (X4)
-ããããÜÜÜÜ+ 50%
Ł 2E.3.2
MEASUREMENT
Ł SENSOR (X4)
-ããããÜÜÜÜ+ 50%
06-05-2007 DP-20 WEB GUIDE CONTROLLER Figure Sheet 1-862-D