- 8 -
1600-GB_SCHLEPPERVORAUSSETZUNG_2740
TRACTOR REQUIREMENTS
GB
Tractor
To operate the implements the following tractor requirements must be met:
- Tractor power: TOP 842 C from 55 kW / 75 HP
TOP 962 C from 63 kW / 85 HP
- Hitching:
Lower link Cat. II
- Connections:
See table "Necessary hydraulics and power connections"
Ballast weights
Ballast weights
The front of the tractor is to have sufficient ballast to
guarantee braking and steering capabilities.
At least 20% of the tractor’s tare weight
on the front axle!
Lifting gear (three-point linkage)
- The tractor’s lifting unit (three-point linkage) must be
designed for the load that occurs. (See technical data)
- The lifting struts are to be set at the same length (4)
using the relevant adjusting equipment
(See the tractor manufacturer’s operating manual)
- Select the rear position if the lifting rods can be adjusted
in various positions on the lower link. This relieves the
pressure on the tractor’s hydraulic system.
- The limiting chain or lower link stabilisers (5) are to
be set so that the coupled implement CANNOT move
sideways. (Safety measure for transportation)
Necessary hydraulic connections
Design
Consumer
Single-acting
hydraulic connection
Double-acting
hydraulic connection
Standard
Lifting and lowering the rotor units
X*)
Hydraulic working width adjustment
X
*) Floating position required
Power connections required
Design
Consumer
Pin
Volt
Power connection
Standard
Lighting
7-pin
12 V DC
According to DIN-ISO 1724
Variant
electrohydraulic single rotor
operation
2-pin
12 V DC
according to DIN-9680
20%
Kg
371-08-16
371-08-16
