GB
OPERATION
1600_GB-Operation_2740
- 13 -
2. Adjusting the outer tines - approx. 1.0 - 1.5 cm
above the ground.
With a TOP 842 C, all the wheels (a-c) can
be adjusted using an eccentric screw.
a1
b1
b2
c
a2
With a TOP 962 C, the dual feeler wheel (c)
has a spindle for an adjustment system
a1
b1
b2
c
a2
Evenly set the wheels which are located
on the side of the rotor unit (a1 and a2
and/or b1 and b2)
a. Eccentric screw system:
3
2
a1
b1
b2
c
a2
1. Loosen the nuts (3) slightly using open-end spanner
No. 36.
2. Set the required incline using the eccentric bolt (2)
and an open-end spanner No. 36.
3. Retighten the nuts (3). (Tightening torque 280 Nm)
b. Adjustment spindle system:
1
2
1. Loosen the nuts (1)
2. Set the spindle (2) at the required length
3. Tighten the nuts (1)
2. Adjusting rake height
1. Set rake height using the hand crank (1) - individually for
each rotor unit. Turn crank (1) anti-clockwise to increase
the distance of the tines to the ground. Turn crank (1)
clockwise to decrease the distance of the tines to the
ground.
- Inside tines should lightly touch the ground (approx.
10-20 cm) depending on forage quantity.
2,0 cm
- Adapt working height to ground conditions.
- The fodder becomes dirty and/or the sward is
damaged if the setting is too low.
- Check the setting frequently during operation.
