7
1. Use a screwdriver to open the cover located on the side of the Server.
2. Connect the SATA adaptor and the power source.
3. Slide the hard disk drive into the slot.
4. Tighten the two screws firmly on the side of the hard disk drive to secure the hard disk
drive.
5. Close the lid. Tighten the screw to secure the cover.
Installing the Foot Stand
Place the Server upside down and follow the steps below to install the foot stand:
1. Aim the tabs on the foot stand at the notches on the bottom of the Server, with the
arrow on the foot stand toward the bottom plate of the Server.
2. Insert the tabs on the foot stand into the notches on the bottom of the Server.
3. Press the foot stand toward the bottom plate of the Server until it snaps into place.
Making the Connections
1. Connecting the power
Plug the receptacle end of the power cord into the power socket on the rear
panel of the Server.
Plug the other end of the power cord into a standard power outlet.
2. Connecting a PC directly to the Server (for the initial setup).
Please connect a cable from the LAN port on the PC to the LAN port on the
rear panel of the Server.
(To connect the ADSL modem to the Server, wait until after you finish Setup
Wizard process.)
3. Connecting the whole network
Connect a network cable from ADSL modem to the WAN port on the rear
panel of the Server.
Connect a network cable from the Hub to the LAN port on the rear panel of
the Server.
Connect a network cable from the Hub to the LAN port on the PC.
