Planar DOME Md4/PCV, Installation Manual, Page: 70 / 88

60 | Installing the Board and Driver
If your edits result in a refresh rate that matches the whole-
number value of an existing refresh rate for an existing
resolution, the mode corresponding to the new refresh rate
overwrites the mode corresponding to the existing refresh
rate in the
.dom
file.
For example, assume you are editing a mode of 2048 x 1536 x
8 @ 75.43 Hz. If you make changes that result in a new refresh
rate of 75.8 Hz, 2048 x 1536 x 8 @ 75.8 Hz replaces 2048 x
1536 x 8 @ 75.43 Hz when you save the mode.
11. Click OK to close the Display Properties dialog box and
Restart your system.
To remove modes
1. Highlight the resolution for the mode you want to remove,
and click Remove Mode. (You can remove any mode except
the current mode.)
A dialog box asks whether you are sure you want to remove
the mode.
2. Click Yes to remove the mode, or No to cancel.
3. Click OK to close the Display Properties dialog box and
Restart your system. Settings take effect after you restart
the system.
You must restart your system for the new mode to take
effect. The device driver cannot recognize changes to
the configuration file until you restart.