Planar DOME Md4/PCV, Installation Manual, Page: 19 / 88

Preparing for Board Installation | 9
This table shows the setting options for DIP switch S1. Change
these settings to enable or disable VGA mode, as described in the
following sections.
To enable VGA mode
Slide the DIP switches on switch S1 into the positions shown in
this table.
DIP Switch On Off
1 VGA disabled VGA enabled
a
a. Indicates factory setting.
2 EPROM enabled
a
EPROM disabled
3 Standard Md4/PCV
a
VGA boot messages appear on
high-resolution monitor
4 Select low BIOS
a
Select high BIOS
Use switch S2 to select monitor resolution when you enable
the option to display VGA boot messages on a high-resolution
monitor. For more information, see “To enable VGA boot
messages on a high-resolution monitor” on page 10.
DIP Switch Setting
1 OFF
2 ON
3 ON
4 ON