Planar DOME Md4/PCV, Installation Manual, Page: 20 / 88

10 | Installing the Board and Driver
To disable VGA mode
Slide the DIP switches on switch S1 into the positions shown in
this table.
To enable VGA boot messages on a
high-resolution monitor
Set DIP switch 3 on switch S1 to OFF and DIP switches 2 and 4 to
ON. This table describes the settings.
DIP Switch Setting
1 ON
2 OFF
3 ON
4 ON
The default settings for switch S2, located to the left of switch S1,
are all OFF.
DIP Switch Setting Note
1 OFF If OFF, the Md4/PCV board acts as the
VGA device, but the output is directed to
the high-resolution screen instead of the
VGA connector.
ON If ON, the Md4/PCV board copies text
from the VGA device to the high-resolution
monitor.
2 ON Must be ON.
3 OFF Lets you direct VGA boot messages to the
high-resolution monitor.
4 ON Must be ON.