Planar DOME Md4/PCV, Installation Manual, Page: 25 / 88

Connecting the Monitors | 15
Connecting the Monitors
Once the Md4/PCV board is installed in your computer,
connect the monitors to the board with the cable provided.
For the Md4/PCV2 board, the cable has two branches, each
with three connectors.
Use this table to attach the cables to the appropriate output
signals on the two monitors.
To connect the monitors to the board
1. Attach the D-shell connector to the Md4/PCV board.
2. Secure the connection with the screws on the connector.
3. Attach each of the output cables to the appropriate BNC
terminal on your monitor.
4. Repeat step 2 for each monitor you want to connect to the
Md4/PCV board.
Monitor Cable Label Output Signal
Monitor 1 VIDEO1 Monitor 1 video
VSYNC1 Monitor 1 vertical sync
HSYNC1 Monitor 1 horizontal sync
Monitor 2 VIDEO2 Monitor 2 video
VSYNC2 Monitor 2 vertical sync
HSYNC2 Monitor 2 horizontal sync
If you are using only one monitor, use the settings for Monitor 1.
Refer to your monitor documentation for more information
about the connector assignments on your monitor.