Pitney Bowes Relay 1000, Operator'S Manual, Page: 39 / 64

Run a Job ● 3
3-15 SV63176 RevB
Job 10
• Two collated, folded sheets
• One insert
• Into an envelope
• Configuration required: Relay 1000
with Insert Feeder C and optional
Sheet Feeder A2
NOTE : This job uses the second sheet feeder A2 in 2nd Page mode to
feed two-sheet, collated sets. Load sheets into the feeder in collated
sequence: first page, second page, first page, second page and so on.
Inserts are pre-folded sheets or unfolded items such as business reply
envelopes, response cards and so on.
STEP ACTION TIP
1 Make sure the paper size
setting is correct.
NOTE: This setting is not
available on all models.
Select 11” or 14” .
2 Load addressed sheets into
Sheet Feeder A2. See notes
above for loading sequence.
Load face down and bottom
edge first.
3 Load second sheets into Sheet
Feeder B.
Load face down and bottom
edge first.
4 Load inserts into Insert Feeder
C.
Loading orientation depends
on item.
5 Press button to select Feeder
A2 and 2nd Page .
Make sure BOTH green
indicators are lit.
6 Press button to select
Envelope Fdr B and Insert
Fdr C .
Make sure BOTH green
indicators are lit.
7 Press button to choose Seal or
No Seal .
Make sure moistener has E-Z
Seal® or water.
8 Press the Trial Piece button
and inspect trial piece
Trial piece will not seal - this is
normal.
9 Press the Start button to run
job.
The Stop button will stop the
system at the end of the cycle.