Pitney Bowes Relay 1000, Operator'S Manual, Page: 30 / 64

3 ● Run a Job
3-6 SV63176 RevB
Job 1
• One folded sheet
• Into an envelope
•
Configuration required: any Relay 1000
NOTE : If your system has the optional 2nd sheet feeder A2, you can use
it instead of A1, as long as you load and select it as described in steps 1
and 3 below.
STEP ACTION TIP
1 Make sure the paper size
setting is correct.
NOTE: This setting is not
available on all models.
Select 11” or 14” .
2 Load sheets into Sheet
Feeder A1.
Load face down and bottom
edge first.
3 Load envelopes in Feeder B. Load right way up and facing
you.
4 Press button to select Feeder
A1 .
Make sure indicators are green.
5 Press button to select
Envelope Fdr B .
Make sure indicators are green.
6 Press button to choose Seal
or No Seal .
Make sure moistener has E-Z
Seal® or water.
7 Press Trial Piece button and
inspect trial piece.
Trial piece will not seal - this is
normal.
8 Press the Start button to run
the job.
The Stop button will stop the
system at the end of the cycle.