Pitney Bowes Relay 1000, Operator'S Manual

Page: 15 / 64

System Overview • 1
1-9 SV63176 RevB
Move the Address in the Window
This menu option allows you to change the length of the fold panel so that
the address is centered in the envelope window. Make the adjustment
by entering a number from 1 to 9. The higher the number, the higher the
address will appear in the window. The screen displays: Shift...X (where X
is the current setting).
1. Press the
Menu/Enter button repeatedly until the display shows:
Move Address in Window?
2. Press yes ( ) to enter the function. The screen displays: Shift.... X .
(X is the current setting). Pressing no ( ) takes you to the next menu
option.
3. Set the desired number using the yes ( ) and no ( ) buttons.
4. When you reach the setting you want, press the
Menu/Enter button to
confirm it. This takes you to the next menu option.
5. Run another trial piece and check it.
• If the address is centered in the window, press Start to run your
job.
• If the address is not centered, repeat the procedure until you get
the result you want.
Sheet Double Detect On/Off
Use this option to turn sheet feeder double detection (Sheet DD) on or off.
•
When Double Detect is turned on - the system stops automatically
when it senses a double feed (two sheets feed when only one should).
If you’re running a job with individually addressed sheets, it’s best to
turn double detection on.
• When Double Detect is turned off - the system ignores any double
feeds that may occur. You may want to leave double detection off if
you are running a mail job and occasional duplicate inserts are not a
concern.
1. Press the Menu/Enter button repeatedly until the display shows the
sheet DD status: Sheet DD is On (Off). Change?
2. Press yes ( ) to change the sheet double detect status. The display
will confirm the change. Or, Press no ( ) to go to the next menu option
without changing this setting.