Pitney Bowes AddressRight DA70S, Operator'S Manual

Page: 20 / 74

Printer Basics • 2
2-3 SV61665 Rev. C
Setting Up a Job
Setting up a print job means adjusting the printer to accommodate
the width, height, thickness and weight of your material.
There are two things that determine how reliably your printer feeds:
the setup adjustments and the quality of your material. A good setup
minimizes misfeeds and jams. And your printer will perform at its best
when you run material that falls within our published specifications.
Please see Appendx A, Specfcatons for complete material
specifications.
1. Setting the Separator Gap
Whenever you switch from one material type to another, you
need to set the gap between the separators and the feed roller
before printing begins.
NOTE: There are three positions of the "H" Blocks.
• Lever fully down - adjusted to media thickness (ready to
operate).
• Lever midpoint - not adjusted to any media (free floating on
media, not set up to operate).
• Lever fully up - locked in the up position, not adjusted to any
media thickness.
H-Blocks