Pitney Bowes AddressRight DA70S, Operator'S Manual, Page: 15 / 74

1 • Introduction
1-8 SV61665 Rev. C
2
Feed Ramp and Lock Knob - The feed ramp adds a gentle
slope to the stack to help feeding. Lower the ramp until the
top of the bottom piece in the stack reaches the middle of
the ramp. Secure the ramp with the lock knob.
3
Input Guide - Supports the material stack.
4
Input Guide Slide and Lock Knob -
Move the slide up and
down to adjust the feed angle to accommodate the weight
of the material you're running. Move the slide forward and
back to adjust its side-to-side position of the input guide so
it's centered under the stack Secure the slide with the lock
knob.
5
Media Thickness Knob - The media thickness knob sets
the distance between the printhead and the material.
6
Control Panel - Use the control panel buttons to access
printer menus, define print options, run the print job, position
the print carriage and turn the printer on and off line.
7
Interface Panel (Not Shown) - Located on the lower part of
the rear cover, the panel has the ON/OFF switch, USB and
Ethernet cable connectors and power cord receptacle. See
figure on page 1-9.
8
Side Guide - Helps confine the stack. Adjust to the width of
your material plus 1/16" (2mm) clearance.
9
Output Stacker Tray - Printed material is deposited in the
stacker (catch) tray. The tray holds about 5" (130mm) of
material.
10
Printer Area Door Assembly (Not Shown) - Open to gain
access to the printer cartridges and exit rollers. See figure
on page 1-9.
11
Exit Rollers (Not Shown) - Guides the printed material as it
exits the printer. Adjust so that each roller overlaps the edge
of the material by 1/4" (6mm). See figure on page 1-9.