Pioneer PRA-BD11, Service Manual

Page: 68 / 98

PRA-BD11
68
1 2 3 4
1 2 3 4
C
D
F
A
B
E
15. Operation check to verify connections
Connect a video monitor to the video out and audio out connectors on the PRV-LX1.
Connect the PRV-LX1 power plug to an AC outlet and turn on the power switch onthe rear panel.
Then press the
STANDBY/ON button on the front panel to turn on the power.
[PRA-BD11 input board operation check]
Use a BNC cable to connect the SDI input and AES/ EBU input connectors on the EBU input
connectors on the input board installed in the PRV-LX1 to equipment with SDI and AES/EBU
output connectors.
Output SDI and AES/EBU signals from equipment connected in Step .
Set the input on the PRV-LX1 to SDI and AES/EBU
.
Press the FUNCTION button on the PRV-LX1 to open the Function Menu on the video monitor.
Use the CURSOR and ENTER button to select “ SDI ” as [ V Input ] and “ AES/EBU ” as[ A Input ].
Select “SDI” as [V Input] on the Function Menu.
14. Install the top panel in the PRV-LX1.
Use the seven screws removed in
Step 1.
Note:
Check that the FFC cables and the 4-pin
cables are connected to the PRA-BD11
input board and the PRA-BD12 output
board before installing the top panel.
Top panel
PRV-LX1
front panel
Attach model
number label here
13. Attach the supplied model number label to the front panel of the PRV-LX1 and the user
registration card.
Attach one of the two supplied model number labels to the top left of the PRV-LX1 front panel
(see figure below).
Attach the other model number label in the model number label field on the US user registration card
(USA only).
Note:
Clean the area on the top of the front panel before attaching the model number label.
Each board is provided with its own model number label. Attach the correct model number label to
the top of the PRV-LX1 front panel above the installed board.
•
•
•
•