PRA-BD11
63
5
6
7
8
5
6
7
8
C
D
F
A
B
E
5. Attach the cable clamp.
Insert the cable clamp (Locking Wire Saddle) supplied with the unit into the specified aperture in the
PRV-LX1 and secure it.
Note:
The mounting location of the PRA-BD11 input board differs from that of the PRA-BD12 output board.
Make sure that they are installed in the correct location.
PRA-BD12 output board
mounting location
PRA-BD11 input board
mounting location
6. Bend the two PRV-LX1 FFC cables.
When installing the PRA-BD12 output board, bend both PRV-LX1 FFC cables beyond the reinforced
end section away from the output board at a 90
°
angle relative to the reinforcement to ensure that
they do not bulge and come into contact with the output board. See figure below
.
Note:
Make sure that the FFC cable is not disconnected from the PRV-LX1 and that the cable is not exposed
to excessive pressure when bent.
FFC cables
Blue reinforced area
•
•
Summary of Contents for PRA-BD11
Page 19: ...PRA BD11 19 5 6 7 8 5 6 7 8 C D F A B E A 3 4 ...
Page 21: ...PRA BD11 21 5 6 7 8 5 6 7 8 C D F A B E ...
Page 23: ...PRA BD11 23 5 6 7 8 5 6 7 8 C D F A B E B 1 2 2 2 B 2 2 B 2 2 B 2 2 B 2 2 B 2 2 B 2 2 B 2 2 B ...
Page 25: ...PRA BD11 25 5 6 7 8 5 6 7 8 C D F A B E B 2 2 1 2 B 1 2 B 1 2 B 1 2 B ...
