Pioneer PRA-BD11, Service Manual

Page: 61 / 98

PRA-BD11
61
5 6 7 8
5 6
7
8
C
D
F
A
B
E
3. Remove the rear bridge.
Remove the four installation screws and the rear bridge (these screws will be used to reinstall the
bridge in Step 9).
2. Remove the rear panel blind plate.
To prevent the blind plate from dropping, hold it in place while removing the two black installation
screws (these screws will be used to reinstall the terminal cover in Step 12).
1. Remove the PRV-LX1 top panel.
Remove the seven screws in the top panel
and the top panel (these screws will be
used to reinstall the top panel in Step 14).
Top panel
Remove the blind plate on the
left (as seen from the rear) to
install the PRA-BD11 input board.
Blind plate
Remove the blind plate on the
right (as seen from the rear) to
install the PRA-BD12 output board.
Rear bridge
Note:
Make sure that the removed
screws are not mixed up with
the screws supplied with this
unit.
Note:
Make sure that the removed
screws are not mixed up with
the screws supplied with this
unit.
•
•
•
INSTALLATION