Additional information
13
124
En
Other audio problems
No sound from subwoofer.
• Check that the subwoofer is connected properly, switched on and the volume turned up.
• If your subwoofer has a sleep function, make sure it is switched off.
• Make sure that the Subwoofer setting is
YES
or
PLUS
(see
Speaker Setting
on page 115).
• The crossover frequency may be set too low; try setting it higher to match the characteristics of
your other speakers (see
Speaker Setting
on page 115).
• If there is very little low frequency information in the source material, change your speaker settings
to Front:
SMALL
/ Subwoofer:
YES
, or Front:
LARGE
/ Subwoofer:
PLUS
(see
Speaker Setting
on
page 115).
• Check that the LFE channel is not set to
OFF
, or to a very quiet setting (see
Setting the Audio options
on page 76).
• Check the speaker level settings (see
Channel Level
on page 116).
Sound is produced from
analog components, but not
from digital ones (DVD, LD,
CD-ROM, etc.).
• Check that the input signal type is set to
DIGITAL
(see
Choosing the input signal
on page 62).
• Make sure that the digital input is assigned correctly for the input jack the component is connected
to (see
The Input Setup menu
on page 45).
• Check the digital output settings on the source component.
• If the source component has a digital volume control, make sure this is not turned down.
• Make sure that the multichannel analog inputs are not selected. Select any other input function.
No sound is output or a noise is
output when Dolby Digital/DTS
software is played back.
• Check that your DVD player is compatible with Dolby Digital/DTS discs.
• Check the digital output settings of your DVD player. Make sure that the DTS signal output is set
to On.
• If the source component has a digital volume control, make sure this is not turned down.
No sound when using the
Home Menu
.
• If the HDMI input function is selected, sound is muted until exiting the
Home Menu
.
Symptom
Remedy
Broadcast stations cannot be
selected automatically, or
there is considerable noise in
radio broadcasts.
For FM broadcasts
• Fully extend the FM wire antenna, adjust the position for best reception and secure to a wall, etc.
• Use an outdoor antenna for better reception (see page 37).
For AM broadcasts
• Adjust the position and direction of the AM antenna.
• Use an outdoor antenna for better reception (see page 37).
• Noise may be caused by interference from other equipment, such as a fluorescent light, motor,
etc. Switch off or move the other equipment, or move the AM antenna.
Speaker switching sound
(clicking sound) is heard from
receiver during playback.
• Depending on the listening mode, the front height (or front wide) and surround back speakers may
switch automatically in function of changes in the input audio. A speaker switching sound (clicking
sound) will be heard from the receiver at this time. If this sound bothers you, we recommend
changing the listening mode (see
Listening in surround sound
on page 59).
Noise is output when scanning
a DTS CD.
• This is not a malfunction of the receiver. The scan function of your player alters the digital
information, making it unreadable, resulting in noise being output. Lower the volume when
scanning.
When playing a DTS format LD
there is audible noise on the
soundtrack.
• Make sure that the input signal type is set to
DIGITAL
(see
Choosing the input signal
on page 62).
Can’t record audio.
• You can only make a digital recording from a digital source, and an analog recording from an
analog source.
• For digital sources, make sure that what you’re recording isn’t copy protected.
• Check that the
OUT
jacks are properly connected to the recorders input jacks (see
Connecting the
multichannel analog inputs
on page 34).
Subwoofer output is very low.
• To route more signal to the subwoofer, set it to
PLUS
or set the front speakers to
SMALL
(see
Speaker Setting
on page 115).
Everything seems to be set up
correctly, but the playback
sound is odd.
• The speakers may be out of phase. Check that the positive/negative speaker terminals on the
receiver are matched with the corresponding terminals on the speakers (see
Connecting the
speakers
on page 24).
Symptom
Remedy
12he_Additional_info.fm 124 ページ ２０１０年４月２０日 火曜日 午前１１時１４分
Summary of Contents for Elite SC-35
Page 145: ...Additional information 13 145 En 12he_Additional_info fm 145 ページ ２０１０年４月２０日 火曜日 午前１１時１５分 ...
Page 146: ...Additional information 13 146 En SC 37_35_UXJCB book 146 ページ ２０１０年３月９日 火曜日 午前９時３２分 ...
Page 147: ...Additional information 13 147 En SC 37_35_UXJCB book 147 ページ ２０１０年３月９日 火曜日 午前９時３２分 ...
