25
En
03
Putting the batteries in
the remote control
1
Open the battery compartment cover on the back of the
remote control.
2
Insert four AA/LR6 alkaline batteries into the battery
compartment following the indications (
,
) inside the
compartment.
3
Close the cover.
Caution
Incorrect use of batteries can result in hazards such as leakage
and bursting. Please observe the following:
• Don’t mix new and old batteries together.
• Don’t use different kinds of battery together — although they
may look similar, different batteries may have different voltages.
• Make sure that the plus and minus ends of each battery match
the indications in the battery compartment.
• Remove batteries from equipment that isn’t going to be used for
a month or more.
• When disposing of used batteries, please comply with
governmental regulations or environmental public instruction’s
rules that apply in your country /area.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater. This
can cause batteries to leak, overheat, explode or catch fire. It
can also reduce the life or performance of batteries.
Using the remote control
Please keep in mind the following when using the remote control:
• Make sure that there are no obstacles between the remote and
the remote sensor on the unit.
• Remote operation may become unreliable if strong sunlight or
fluorescent light is shining on the unit’s remote sensor.
• Remote controllers for different devices can interfere with each
other. Avoid using remotes for other equipment located close to
this unit.
• Replace the batteries when you notice a fall off in the operating
range of the remote.
• Use within the operating range in front of the remote control
sensor on the display unit, as shown.
30°
30°
7 m
LX01BD_1.book Page 25 Tuesday, September 2, 2008 12:33 PM
