08
42
En
Connecting an iPod
You can use the
iPod
jack on the display unit to playback music from
an iPod. All operations can be carried out via the iPod. Use the
supplied iPod cable to connect an iPod to this unit.
• When you connect an iPod, this unit’s input automatically
switches to
iPod
.
• Certain iPod models have connectors that are not compatible
with this unit.
iPod is a trademark of Apple Inc., registered in the U.S. and other
countries.
Listening to an external audio source
To listen to audio from a connected external component on this unit,
choose its input function on the remote control. Some Pioneer
products can be controlled via this remote.
1
If the system isn’t already on, press SYSTEM ON to switch on.
Also make sure that the external source (TV, satellite receiver, etc.)
is switched on.
2
Press LINE to select an audio input source.
Input sources are cycled through as shown below:
The display changes to that of the selected input source.
3
If necessary, start playback of the external source.
Connecting external antennas
For an external AM antenna, use 5 to 6 meters of vinyl-insulated wire
and set up either indoors or outdoors. Leave the loop antenna
connected.
For an external FM antenna, use a PAL connector to hook up an
external FM antenna.
About control out connections
Many Pioneer components support CONTROL connections, by
which you can use the remote controls of any connected
components by aiming them at the sensor of just one component.
When you use a remote control, the control signal is passed along
the chain to the appropriate component.
If you choose to use this feature, you must make sure that you also
have at least one set of HDMI or analog audio jacks connected to
another component for grounding purposes.
Using a cable with mono mini-plugs on either side (sold
separately), connect the CONTROL IN jack on another Pioneer
component to the CONTROL OUT jack on the receiver
subwoofer.
This will allow you to control the other component by pointing its
remote at the display unit supplied with this receiver subwoofer.
F.AUDIO
DISPLAY UNIT
iPod
MCACC
SETUP MIC
SYSTEM
iPod
MENU
Display unit
iPod cable
(inc
luded)
iPod
INPUT
BD
DVR
DVD
TV
ON
SYSTEM
OFF
HDMI 1
HDMI 2
HDMI 3
TV
ON
SYSTEM
MCACC
SOUND
DIRECT
TEST
TONE
SOUND
RTRV
LINE
LINE
Digital 2
Front Audio In
iPod
Analog
Digital 1
AM LOOP
FM
UNBAL 75
Ω
ANTENNA
Receiver subwoofer
Side panel
AM loop antenna
External FM antenna
External AM antenna
Indoor antenna
(vinyl-coated wire)
5 m to 6 m
Outdoor antenna
PAL connector
LX01BD_1.book Page 42 Tuesday, September 2, 2008 12:33 PM
