36
DJS-1000
1
2
3
4
A
B
C
D
E
F
1
2
3
4
Remove the Stay
while pulling the
Earth Lead Wire
out of the hole.
SSK3 ASSY
Front
∗
7
∗
7
∗
8
SW POWER SUPPLY
Remove the two
Acetate Cloth Tapes.
CN2
CN1
2
1
x 10
:
x 11
:
rib
Holder
∗
9
∗
9
Front
Front
Front
Shield Case
Stay
Stay
AC Inlet
AC Inlet
Front
Earth Lead Wire
Unhook from the Holder.
Earth Lead Wire
[2-2-4] SW POWER SUPPLY
Remove the MAIN ASSY and AUDB ASSY.
(Refer to the
“[2-2-2] MAIN ASSY”
and
“[2-2-3] AUDB ASSY”
.)
-----------------------------------------------------------------
Remove the ten screws (BPZ30P080FNI) and then remove
the Shield Case (DNH3326).
Disconnect the two connectors.
Note
∗
7: CN1 and CN2 have lock mechanisms.
Remove the two screws. (BPZ30P080FNI)
Remove the four screws (BBZ30P060FTB) and then remove
the SW POWER SUPPLY.
Note on assembling:
Attach first two screws in the order as shown by blue numbers.
Remaining two screws can be attached in any order.
[2-2-5] AC Inlet
Remove the SW POWER SUPPY.
(Refer to the
“[2-2-4] SW POWER SUPPLY”
.)
-----------------------------------------------------------------
Release the AC inlet cable from the Holder (VEC1355).
Remove the two screws (BPZ30P080FNI) and then remove the
SSK3 ASSY.
Notes on assembling
∗
8: AC inlet cable must pass through the rear side of the Chassis’s rib.
∗
9: Style
the AC inlet cable so as not to touch the Stay (DNH3323)
and screws.
Remove the screw. (BBZ30P060FTB)
Note:
After the product No.1711 only.
Remove the 11 screws. (BPZ30P080FNI)
Remove the Stay (DNH3323) while pulling the AC inlet cable out of
the hole.
Note:
LSYXJ: Lot 1 to 1010 and UXJCB: Lot 1 to 640 have the Earth
Lead Wire (DDX1286).
For details, refer to the
“[3-2-2] Correspondence
for Earthing Improvement”
