26
DJS-1000
1
2
3
4
A
B
C
D
E
F
1
2
3
4
PAGE
5 : BUTTONS, PADS
•
Mode for confirmation of the buttons
•
S
elf-illuminating buttons are lighting as default value.
If it is pressed, it will be turned OFF.
•
S
tatus of the pressed button is displayed at ****** in the
upper left.
• If pressing all buttons is completed, characters [OK] will be
displayed on the right side of RE
S
ULT display.
PAGE
6 : VOLUMES, RIBBON, TEMPO SLIDER
PAGE
7 : ENCORDERS
PAGE
8 : TOUCH PANEL
•
Mode for confirmation of the VRs(AD Value)
• For each operation, characters [OK] are displayed when
the value reaches the predefined voltage value of upper
limit and lower limit values.
********
: [ON, OFF]
LED-Button(**/
3
6)
: [OK]
Button(*/5)
: [OK]
Pad(**/16)
: [OK]
Nudge(*/2)
: [OK]
Result
: [OK]
[PAGE 5] Buttons, Pads
HeadPhone
:
[OK]
FX Level Depth :
[OK]
Ribbon Position :
[OK]
Tempo
S
lider
:
[OK]
[PAGE 6] Volumes, Ribbon, Tempo Slider
XXX(VALUE)
XXX(VALUE)
XXX(VALUE)
XXX(VALUE)
S
elector
:
S
elector Push
S
tate
: [ON, OFF]
ENCODER (1)
:
0
ENCODER (2)
:
0
ENCODER (
3
)
:
0
ENCODER (4)
:
0
ENCODER (5)
:
0
ENCODER (6)
:
0
[PAGE 7] Encoders
Touch dots
[PAGE 8] Touch Panel
•
Mode for confirmation of the Encoders
Turn it clockwise to +5 or more, turn it counterclockwise and
set to -5 or less, it will be checked OK.
•
S
elector also displays the status when it is pushed.
When it is pushed, "ON" is displayed. When it is
not pushed, "OFF" is displayed.
•
Check using a touch pen with small tip is recommended
•
Mode for checking the accuracy of touch point.
•
If you touch squares at four corners shown above, they will
become blue.
If you touch all squares, check result will become OK.
•
If you press REC button, mode will shift to the calibration mode.
While touching the center of + mark of red square in the
upper left, press REC button.
While touching the center of + mark of red square in the
upper right, press REC button.
While touching the center of + mark of red square in the lower left, press REC button.
While touching the center of + mark of red square in the lower right, press REC button. Calibration will be completed.
(If the calibration is completed by pressing REC button without touching it, calibration value will be discarded.
Touch motion will be operated without calibration.)
*
Calibration of the touch panel, carried out only at the time of check NG.
