ZX Series USER MANUAL
58
The three LED indicator lights above the Directional Buttons display the status of the
machine’s power and safety functions. The LASER indicator light will inform you if the laser
is actively firing. The DOOR light will inform you if either the Top Door or Front Door is
open. If either door is open, the ZX SERIES’s safety interlock mechanism will prevent the
laser from firing. The POWER light will come on when the machine is plugged into an
appropriate power source.
Function Buttons
The F1, F2, F3, & F4 buttons let you select the various available options located on the
lower portion of the graphic control panel. These buttons will allow you to scroll through the
control panel menu, access help pages, and pause and resume jobs.
The AUTO FOCUS button will activate the Focal Sharp
TM
Auto-Focus Gauge while in the
Main Operation Page.
The START/STOP button will let you start and pause jobs once they have been successfully
loaded into the Pinnacle ZX SERIES.
Display
When you start transmitting files to ZX SERIES, the control panel would display as following:
When the Pinnacle
ZX Series
is powered on, the machine will perform a series of safety
checks and initializing routines. The graphic control panel will scroll through the GCC
Copyright Page, Table Object Moving Page and the Machine Initialize Page before reaching
the Main Operation Page. Once the machine has reached the Main Operation Page, it is
ready for use. Refer to the diagram of Fig. 5-2 for a detailed listing of the different pages
within the control panel menu.
NOTE:
1. Prior to initialization, the
ZX Series
will display an image of a table on the graphic control
panel. This should prompt you to make sure that the working table area is clear for
unwanted obstructions.
2. Each time when you turn on
ZX Series
, it would run initialization of working table moving
down and up, lens carriage bottom to top and air blowing. Therefore, you have to wait for
few seconds to finish air blowing test before start work.
002 File name
Speed: XX % DPI: XXX
Power: XX % PPI: XXX
XX:XX:XX 001/ 004
File parameters
File sequence and file name
Time calculation
004 means this file will be repeated
four times, and 001 means the file is
running under its first time.
Summary of Contents for LaserPro ZX Series
