Pinnacle LaserPro ZX Series, User Manual

Page: 30 / 123

ZX Series USER MANUAL
29
SIDE VIEW
Fig. 3-22 Rotary Attachment Side View
EngraveLab Rotary Attachment Setup
1) Turn off the laser.
2) Place the rotary attachment onto the engraving table. Ensure the two screw holes on right side of
rotary attachment match the two corresponding holes on the table. The mark on the left side lines up
to the 9.45 inch (24cm) position of on the ruler, then tighten the screws supplied.
3) Plug the cable of the rotary attachment into the port in the middle front of the engraver.
4) Turn on the power and the engraving table moves down to the lowest position automatically.
Operation:
NOTE:
The maximum length of the engraving object is 17.322 inch (450 mm).
The maximum diameter of the padded rubber wheel is 3.70 in (94 mm).
The maximum diameter of the loaded object is 7.09 in (180mm) and the limited loading weight is 15.4 Lb
(7 Kg).
1. Measure and write down the diameter of the engraving object.
2. If you engrave objects with a diameter that is smaller than 3.00 inch’s please use the 2.5 inch or 4
inch lens to prevent collision between carriage and rotary attachment device. If he diameter is 0.001
to 0.92 inch’s use the 4 in lens. If the diameter is between 0.92 and 3.0 inch the 2.5 inch lens will be
needed.
3. Lift the lever, load the engraving object, slide the adjustable end to the bottom of the object firmly,
then lower the lever of the fixture to secure it in place shown as in Fig 6.
4. Focus the laser. (Manual focus is suggested)
5. The following is an example of engraving process by using EngraveLab
.
6. After importing or creating an image, click on File then Print.
Base of the padded
rubber wheel
Open end of the working piece
Lever
motor
Adjustable end
Offset
Value
The length of working piece