English
38
USE
ENABLE BEEP (audio signal)
This function allows you to engage or disengage the alarm signal emitted by the stove to indicate that it has received the remote
control's commands.
Function
Action
Display
Select enable beep
menu
Press the MENU key. Using the SELECT MENU
key select the
ENABLE BEEP
menu and confirm
by pressing the SET key.
MENU
SET
ESC
OPT
Select
enable
or
disable beep.
Press the SELECT MENU
key and select
on
to
enable the buzzer or
off
to disable it. Confirm by
pressing the SET key. After confirmation the
readout
BUZZER ENABLES
will appear on the
display while the initial display will automatically
reappear on the remote control.
MENU
SET
ESC
OPT
E N A B L E
B E E P
!
M O D E
B E E P
!
O N
DT2040065-03
STATE STOVE
This function displays the stove status under the various operating conditions.
Function
Action
Display
Select stove status
menu
Press the MENU key, then using the SELECT
MENU
key select the stove status
STATE
STOVE
menu. Confirm by pressing the SET key.
MENU
SET
ESC
OPT
Display stove status
The first line displays the operating conditions, the
second line for how long the pellets have been
loading and the third line the smoke and room
temperatures detected by the sensors. A list of the
readouts which can appear in the first line is given
below:
PUL
Clean grate
ALF
Pressure switch activated
ALC
Safety thermostat activated
No Conn
Smoke sensor disconnected
No Acc
Failed ignition
Mass temp
Smoke alarm activated - maximum
temperature reached
S T A T E
S T O V E
!
P U L
0 2 . 4 c o
!
0 9 5
2 6
.
c
.
c
DT2040071-04