Photron FASTCAM ultima APX-i2, Hardware Manual

Page: 45 / 147

FASTCAM-ultima APX-i2 Hardware Manual
-43-
③
Confirming settings of camera
When the camera has been set up, II POWER OFF is displayed on the video monitor. If it is not
displayed, the camera head has not been correctly set up. Reset the camera carefully.
④
Switching intensifier power on
After the camera has started up, reconfirm the II switch on the back of the camera head is off. Turn
on the power SW on the back of the camera processor. The SW LED does not light at this time.
Press the MENU button on the keypad to open the menu. In the <II POWER> part, select ON with
the enter key of the keypad. When the selection is confirmed, the SW LED (green) on the camera
head lights indicating the intensifier has been powered. With the LED on, operation of the
intensifier is reflected in the image on the monitor.
RESERVED
LUT SELECT
CALIBRATE
DS SHUTTER
DIGITAL I/F SET
TIME SET
DATE/TIME
SHUTTER STEP
SYSTEM REV
SHUTTER MODE
STATUS OUT
RESERVED
HEAD EXCHANGE
II POWER
II GAIN GATE
II GATE SELECT
II PROTECTION
RESERVED
2000FPS 1024X1024 1/2000s
II POWER
OFF
ON
ON LOAD
RESERVED
LUT SELECT
CALIBRATE
DS SHUTTER
DIGITAL I/F SET
TIME SET
DATE/TIME
SHUTTER STEP
SYSTEM REV
SHUTTER MODE
STATUS OUT
RESERVED
HEAD EXCHANGE
II POWER
II GAIN GATE
II GATE SELECT
II PROTECTION
RESERVED
II POWER
OFF
ON
ON LOAD
2000FPS 1024X1024 1/2000s