Operation
61-900040-000
Rev. Date:
01/22
3-27
2. Firmly push the other end of the vacuum hose onto the waste tank inlet port.
3. Verify the vacuum seal is in full contact with the waste tank. If not see Section 4.3.6
–
Adjusting the Vacuum Motor Position
.
NOTE
Whenever the waste tank is placed in the machine, use care to not damage the
vacuum pump seal.
3.9 CLEANING THE LANE HEAD AREA
To clean the lane using the Phoenix LT4, place only the front two casters in the gutters and
follow the procedure below. Placing only the front two casters in the gutters will allow the
machine to clean the first 30 inches (76 cm) of the lane.
To clean the lane head area:
1.
Position the machine on the lane with only the front caster wheels in the gutters.
2.
Press the POWER switch to ON.
3.
Press the START button
once
. The Phoenix LT4 starts spraying the cleaning
solution, lowers the vacuum head, and starts the vacuum motor.
4.
Push the Phoenix LT4 forward until all four caster wheels are in the gutters and
press the start button a second time (within 5 seconds of the first press). The
machine will continue on to clean and/or condition the lane.
3.10 CLEANING AND CONDITIONING
NOTE
It is strongly suggested that the lanes be dusted before a conditioning session.
Dusting the lanes will prolong the life of the foams, squeegee, and buffer brush, and
ensures quality results.
Ensure the bumpers, if installed on the
center’s lanes, are fully retracted before
operating the Phoenix LT4 on a lane.
Bumper rails that protrude above the lane
surface should be repaired or replaced prior to operating the Phoenix LT4.
IMPORTANT!
Ensure the pinspotters are turned off on the lanes being cleaned or conditioned.
When the Phoenix LT4 is first energized, the touch screen will momentarily appear blank
while the system loads. Once loaded, it will automatically select the last used program on
the machine.
For information on programming or changing the factory programming of the Phoenix LT4,
refer to Section 3.2 -
The Phoenix LT4 Lane Machine Controls
.