Introduction
61-900040-000
Rev. Date:
01/22
2-3
All programs may be customized to suit the specific needs of the center. The machine
comes from the factory with four preprogrammed routines: programs A, B, C, and D. Below
is a description of each program.
Program A is single pass with cleaning, oiling, and buffing. It is typical of what would
be applied for recreational or "open" bowlers using mostly house balls supplied by
the bowling center.
Program B is double pass with cleaning, oiling, and buffing. This program lays out a
typical league pattern or bowling club pattern for more experienced bowlers using
performance bowling balls.
Program C is double pass with cleaning, oiling, and buffing. This double pass pattern
is similar to Program B but applies more oil to the lane. This program is generally
used for tournaments and highly competitive leagues or clubs. Typically the majority
of the bowlers will be using performance bowling balls.
Program D is cleaning only single pass. This program can be used to clean the
lanes without applying any oil. It is useful for cleaning the lanes prior to a lane
inspection or to check the cleaning function of the machine.
Additional information about the factory settings and adjusting them can be found in
Section 3.10
–
Cleaning and Conditioning
.
A printout of the specific cross-lane oil pattern produced by the Phoenix LT4 has been
included in a yellow envelope. This printout contains important information about the
mach
ine’s initial settings and should be retained for the center's record.
For more information about oil output and patterns, refer to Section 6 -
Determining the
Oiling Pattern
.