Operation
61-900040-000
Rev. Date:
01/22
3-25
Follow the steps below to fill the cleaner tank.
1. Remove the cap from the cleaner tank.
2. Insert the
large
red funnel into the tank opening. Leave a small gap to allow air to
exit from the tank as it is filled.
Note:
The large red funnel must have a screen in place. Replace the funnel if the screen is
missing or damaged.
3. Pour
diluted
Brunswick Lane Cleaner, or equivalent, into the tank until it is about an
inch below the tank inlet.
4. Remove the funnel.
5. Replace the cap.
6. Wipe up any drips or spills that may have occurred.
3.8.1.2 Adding Oil
As with the cleaner, there are things that must kept in mind when filling the oil tank.
1. Use only oil or lane dressing that is manufactured specifically for use on bowling
lanes.
2. Fill the tank while it is in the normal operating position.
3. Do not overfill the tank. The correct level is just to the bottom of the fill line on the
sight glass.
4. Pour the oil in slowly. Allow time for the oil to disperse throughout the tank.
Because bowlers can slip and fall on oil spilled on the
approach, DO NOT fill the oil tank on the approach.
Fill it 2 to 3 feet down the lane or in an area away from
the lanes, such as the service area by the pinspotters.
Avoid splashing the oil. Follow all instructions and precautions on the product label.
Follow the steps below to fill the oil tank.
1. To access the oil tank, open the oil tank compartment door by unlatching the clasps
keeping it closed.
2. Remove the plug from the top of the oil tank as shown in Figure 3- 44
on the next
page.