Phoenix Contact Nanoline NLC-035-024D-04I-02QRD-05A, User Manual

Page: 96 / 134

Nanoline
92
PHOENIX CONTACT 2338_en_O
– Flags 88-103 are status flags (see Table B-3) and are read only.
If the NLC-COM-GSM module is installed, some flags may be used for other purposes.
Refer to the NLC-COM-GSM user manual for GSM flags.
Table B-2 Ethernet command flags
Flag Name Description
F-72 ETH Set Read-Only Mode On sets all data items to be read-only when
accessed through the Ethernet port
F-73 ETH Command 01 (Reserved) Reserved for future use
F-74 ETH Disable Port On disables the Ethernet port from remote
access from outside network sources
F-75 ETH Request DHCP On requests the Ethernet module to enter a
mode asking for an IP Address from a
DHCP server
F-76 ETH Request BOOTP On requests the Ethernet module to enter a
mode asking for an IP Address from a
BOOTP server
F-77 ETH Enable Web Access On allows the Ethernet module's web
server to be accessed from a network
connection
F-78 ETH Reset to Factory Default On resets the Ethernet module’s
configuration data to the factory default
settings; the IP Address is also reset to
0.0.0.0
F-79 ETH Command 07 (Reserved) Reserved for future use
F-80 ETH Command 08 (Reserved) Reserved for future use
F-81 ETH Request Boot On requests the Ethernet module to stop
communicating to the base to allow the
base module to enter bootloader mode.
F-82 ETH Request Reset On requests the Ethernet module reset
itself to the stored settings
F-83 ETH Command 11 (Reserved) Reserved for future use
F-84 ETH Command 12 (Reserved) Reserved for future use
F-85 ETH Command 13 (Reserved) Reserved for future use
F-86 ETH Command 14 (Reserved) Reserved for future use
F-87 ETH Command 15 (Reserved) Reserved for future use