Hardware installation
104275_en_c00
PHOENIX CONTACT
2-1
2
Hardware installation
Scope of supply
–
SHDSL modem
–
CD-ROM with PSI-CONF configuration software
–
Package slip
Default settings
The device is supplied with the following configuration:
–
Line operation
–
DSL:
Automatic data rate detection in the range from 192 kbps to 5.696 Mbps per channel
DSL port A: active
DSL port B: active
–
Serial interface:
Automatic DTE/DCE detection activated
RS-232 activated, 19.2 kbps, no flow control, 8N1 (8 data bits, no parity, 1 stop bit)
RS-485 deactivated
RS-422 deactivated
–
Digital switching outputs:
Tips for easy startup
Point-to-point connection of two devices
•
Connect DSL port A of device 1 to DSL port B of device 2.
All LEDs light up during the boot process.
If the device is still set to the default settings, the DIAG LED flashes for approximately 20 s
after the boot process.
DSL A
DO = "24 V"
Good to very good connection
DO = "open"
No or only moderately good connection
DSL B
DIO = "24 V"
Good to very good connection
DIO = "open"
No or only moderately good connection
If you wish to configure the modem differently, you must install the PSI-CONF configura-
tion software.