Phoenix Contact 2313643, User Manual, Page: 58 / 94

TC ETH EXTENDER S19
58
PHOENIX CONTACT 104273_en_01
Select wire pairs
In the case of star quad twisted cables, use the single wires on the opposite side (1a/1b or
2a/2b) to avoid crosstalk.
Figure 5-6 Star quad
5.3.1.2 Establishing a connection
The factory configuration allows automatic data rate detection from 192 kbps to 5.696 Mbps
for each connection terminal block. A data rate from 32 kbps up to 15.3 Mbps can be set for
each connection terminal block via the configuration software.
Both "LINK" LEDs indicate the present connection stage of the device. If the "LINK" LED is
permanently on, the connection has been established.
The two "STAT" LEDs indicate the link quality. The longer the LED lights up, the better the
quality of connection (see page 53).
In the case of extremely long lines that are susceptible to interference, automatic detec-
tion of the data rate may not be possible. In this case, specify a fixed data rate via the
PSI-CONF configuration software.
Short flashing of the green "LINK" LEDs indicates that the DSL port is not disabled.
1 a
2 a
1 b
2 b