Phoenix Contact 2313643, User Manual, Page: 85 / 94

Troubleshooting
104273_en_01 PHOENIX CONTACT
85
108 ...
109
Reserved – – – –
Information
171 No more
interference
– Disturbances occurred at a port, but
are no longer present.
DSL_A,
DSL_B,
ETH
–
172 Log overflowed – The log is full (more than 16,000 en-
tries); the oldest events will be over-
written from now on.
– –
173 DSL chip booted
successfully
– The DSL chip was booted success-
fully. Occurs once after every power-
on reset when the device is supplied
with 24 V. The DSL chip will not be
booted when it is supplied via the USB
port only.
– –
174 Ethernet link
established
ETH LINK
on
An Ethernet link has been established ETH –
175 Link partner found DSL LINK
flashing
(1 Hz)
The specified DSL port found a link
partner.
DSL_A,
DSL_B
–
176 Link state
changed to
"Initializing"
DSL LINK
flashing
(2 Hz)
The specified DSL port changes to the
initialization phase.
DSL_A,
DSL_B
–
177 Link established DSL LINK
on
The specified DSL port has estab-
lished a link.
DSL_A,
DSL_B
–
178 USB cable
connected
– A USB cable was connected to the
device.
– –
179 USB cable
removed
– A USB cable was disconnected from
the device.
– –
180 Link quality very
good
DSL STAT
on
The link quality was specified as "very
good".
– –
181 Reserved – – – –
182 Set condition met
for DO
– The set condition is met for the DO. – –
183 The set condition
is met for the DIO
– The set condition is met for the DIO. – –
184 Set condition not
met anymore for
DO
– The set condition is no longer met for
the DO.
– –
185 Set condition not
met anymore for
DIO
– The set condition is no longer met for
the DIO.
– –
Table 7-1 Diagnostic IDs
ID Meaning LED Possible cause(s) Port Remedy