Phoenix Contact 2313643, User Manual, Page: 51 / 94

Hardware installation TC ETH EXTENDER S19
104273_en_01 PHOENIX CONTACT
51
5 Hardware installation TC ETH EXTENDER S19
Scope of supply
– Central communication unit with six autonomous Ethernet extenders
– Package slip
Default setting
– 2-wire operation (4-wire operation is detected automatically)
– DSL: Automatic data rate detection in the range from 192 kbps to 5696 Mbps per chan-
nel
DSL port A: active
DSL port B: active
– Ethernet:
Auto crossing (Auto MDI/MDI-X)
Auto negotiation
Tips for easy startup
Point-to-point connection of 2 devices
• Connect DSL port A of device 1 to DSL port B of device 2.
All LEDs light up during the boot process. If the device still has the default configuration, the
"DIAG" LED lights up after the boot process for about 20 seconds.
To configure the device, the PSI-CONF configuration software must be installed. It is
available to download at phoenixcontact.net/products .