Phoenix Contact 2313643, User Manual, Page: 53 / 94

Hardware installation TC ETH EXTENDER S19
104273_en_01 PHOENIX CONTACT
53
5.2 Connections and LEDs
PSI-MODEM-SHDSL/ETH
Ord.-No. 23 13 643
VCC
DIAG
ACT
LINK
ERR LINK
STAT
LINK
STAT
DSL A
DSL B
ETH
PSI-MODEM-SHDSL/ETH
Ord.-No. 23 13 643
VCC
DIAG
ACT
LINK
ERR LINK
STAT
LINK
STAT
DSL A
DSL B
ETH
2
3
4
5
1
6
7
8
9
Status and diagnostics indicators
1 VCC (green) Supply voltage
On Supply voltage OK
Flashing (1 Hz) Supply via USB (only for configuration)
Flashing (2 Hz) Error during boot process (ERR also flashes)
2 DIAG (yellow) Diagnostics
Off No serious errors
Flashing (1 Hz) (Duration: 20 seconds after booting)
Device is in default settings
Flashing (2 Hz) Remote access from another device (data transmission
during remote configuration, remote diagnostics, firm-
ware update)
On Serious error occurred -
read out of diagnostic data is recommended
3 ACT (yellow) Ethernet interface
On Data traffic on Ethernet interface
4 LINK (green) Ethernet interface
Off No connection
On Connection established
5 ERR (red) Error
Flashing (2 Hz) Error during boot process (VCC also flashes)
On Telegram error/installation error
6 LINK (green) DSL ports
8 Off DSL port not active
Off (pulsating) (Flashing every 3 s) DSL port is searching for link de-
vice
Flashing (1 Hz) Link partner found
Flashing (2 Hz) Initializing connection
Flashing (4 Hz) ERR ON / STAT DSL OFF = Installation error: e.g., line
structure configured, but 4-wire point-to-point connec-
tion implemented
On Connection established
7 STAT (yellow) DSL ports
9 Off No connection established
Off (pulsating) (Lights up every 3 s) Connection quality adequate
On (pulsating) (Goes out every 3 s) Connection quality good
On Link quality very good