Philips VARILITE VL1100 LED Luminaire, User Manual

Page: 28 / 87

VARI
❋
LITE
®
- VL1100 LED
AND
VL1100 LED HP U
SER
’
S
M
ANUAL
12 13 June 2017 02.1602.0002
Power and Data Cabling Requirements
AC Power
WARNING: Other than described herein, do not power a VL1100 LED™ Luminaire from a dimmed
circuit - even in “Non-Dim” mode. Dimmer and non-dim modules are not suitable sources of power
because their output modifies the AC wave form. This may work for a short time, but will eventually
result in power problems, luminaire mis-operation and/or failure. Using a dimmer or non-dim module
to power your VARI
❋
LITE® luminaire will void your luminaire’s warranty.
The luminaire requires standard AC power distribution from 90-264 VAC, 50/60 Hz in order to power
all internal electronics and motors. It is equipped with a 3-pole Neutrik® PowerCon® locking
connector (with contacts for line, neutral, and premating safety grounds) for the purpose of AC
input.The mating Neutrik® powerCON TRUE1 connector is supplied, however, you will need to
purchase or construct a cable appropriate for your application.
Figure 2-1: Power Connector
Current vs. Voltage
“VL1100 LED Luminaire - Current vs. Voltage (460W LED Source)” on page 12 provides the
luminaire’s current draw at specific voltages. Total Luminaire Current is calculated with the lamp on
and all motors sequencing.
WARNING: It is the responsibility of the user to adequately protect supply source with a correct size
and type circuit breaker and not overload circuits. AVERTISSEMENT: Il est de la responsibilité de
l'utilisateur de protéger adéquatement la source d'alimentation avec une taille correcte et le disjoncteur
de type et surchargez pas les circuits.
3-Pole Neutrik
®
Locking Connector
for AC input
Neutrik
®
powerCON TRUE1
Connector (supplied)
Table 2-1: VL1100 LED Luminaire - Current vs. Voltage (460W LED Source)
AC Voltage @ 60Hz Total Luminaire Current (Motor + LED Current)
100V 6.3A
110V 5.7A