Philips DVDR730/0x, Service Manual

Page: 38 / 160

Mechanical Instructions EN 38 DVDR730/0x 4.
4. Mechanical Instructions
4.1 Dismantling and Assembly of the Set
Remark: Exploded views can be found in chapter 10.
4.1.1 Manually opening the tray
– In case the loader is defective or cannot be opened
electrically you can open the tray manually.
– Through a slot at the underside of the cabinet a slider that
unlocks the tray can be accessed.
However the slot is covered by an adhesive tape on the
cabinet of the drive to prevent dust coming into the drive.
Push through this adhesive tape by means of a thin
screwdriver and move the slider to the left, see picture 4-1.
– Make sure that an adhesive tape has been reapplied to
the drive when repair is finished!
Figure 4-1
4.1.2 Front
– Before removing the front panel the tray has to be in the
opened position.
– Remove the top cover
– Remove tray front by pulling it upwards (1), see picture 4-2
– Unplug the IDE cable that connects to the card reader (2),
see picture 4-3
– Remove the 2 screws (3) that fix the card reader
– Remove the card reader PCB (4)
– Remove the screw (5) that fixes the bracket of the card
reader to the front plate, see picture 4-4
– Remove the three screws (6) fixing the front panel
– Release the cables from the clamps (7)
– Release the two snap hooks at the sides (8) and remove
the front (9), see picture 4-5
– Remove the 9 screws (10) to remove the front plate (11),
see picture 4-6, 4-7
Figure 4-2
Figure 4-3
Figure 4-4
Figure 4-5
Figure 4-6
Figure 4-7
1
2
3
3
4
1
5 6
6
6
7
7
8
8
9
10
11