PEUGEOT 208 2017, Handbook

Page: 124 / 304

122
Driving
Registering a limit speed
This can be done without switching the limiter
on, but the engine must be running.
To register a speed higher than the previous
setting:
- Press the SET +
button.
A short press increases the speed setting by
1 mph (km/h).
Pressing and holding increases the setting in
steps of 5 mph (km/h).
To register a speed lower than the previous
setting:
- Press the SET –
button.
A short press decreases the setting by 1 mph
(km/h).
Pressing and holding decreases the setting in
steps of 5 mph (km/h).
On / Pause
A first press on this button switches the speed
limiter on, a second press pauses it.
Exceeding the registered
limit speed
Pressing the accelerator pedal to
exceed the registered speed will not
have any effect, unless you press
the pedal
firmly past the point of
resistance .
The speed limiter is deactivated temporarily
and the registered speed setting flashes,
accompanied by an audible signal.
To return to normal operation of the speed
limiter, reduce your speed to below the
registered speed setting.
Flashing of the speed setting
It flashes:
- after forcing the accelerator pedal past the
point of resistance,
- when the limiter cannot prevent the speed
of the vehicle increasing, because of the
profile of the road or when going down a
steep hill,
- under sharp acceleration.
F
Place the thumbwheel at the 0 position or
switch off the ignition to stop the system.
The last speed registered stays in memory.
Switching the system off