Operation . 43
9.
Press FUNC.
The Lower display shows
S-02
. To add another step to the cycle, repeat the
programming from numbered step 6.
OR
Set the time to 00.00 to end the program. Up to eight steps can be programmed into a
cycle. Use two steps in place of one if the maximum time available is not sufficient for
one step.
10.
Press FUNC.
The Lower display shows
Rep
.
11.
Use the arrow buttons to set the number of cycle repetitions.
Entering this value as 1 will run the program once only.
12.
Press FUNC.
This completes the cycle program and this will be stored by the machine until it is
edited. The system returns to STOP mode. The Upper display shows the current
temperature, whilst the Lower display shows
C-01
or
C-02
, depending on the cycle you
were editing.
Summary of Contents for PTP-1
