EAC12
2
PEREL
4. Part denomination
1. air outlet with wind direction tab (on the right)
2. control panel
3. handle
4. remote control compartment
5. condensed water tank
6. interior air inlet
7. drainage outlet
8. ventilation air outlet
9. power cable
10. ventilation air inlets
Control panel
1. ON/OFF: to switch the device on and off. The device will always power on using the settings as they were when it
was switched off. The first time the unit is switched on, it will be in auto mode.
2. MODE: to switch between operating modes: AUTO, COOL, DEHUMIDIFY, FAN. The corresponding symbol will be
displayed on the LCD (see below)
3. SPEED: to select fan speed: LOW, MID or HIGH. The fan speed is also displayed on the LCD (fig.4 #6).
4. LCD panel (see below)
5. TEMP
▲
/
▼
: to adjust the temperature setting (only in cooling mode) by pressing the corresponding end of the
button. The selectable range is 15-31°C. In AUTO mode, the temperature is 23°C by default.
6. TIMER: to determine a time after which the device will power on or off. When the device is switched on, you can
set a time the device will keep on working (0.5 to 12 hours), after which it will power off. When the device is
switched off, you can set a time the device will remain inactive (0.5 to 12 hours), after which it will power on.
7. WIND: to make the vertical plates swing sideways in order to obtain a better air distribution. This function is not
available in dehumidifying mode. The vertical blowing direction is manually adjustable by means of the tab on the
right of the air outlet (see fig.1 #1).
LCD panel
1. auto mode
2. cooling mode
3. fan operating
4. WIND-function activated
5. dehumidifying mode
6. fan speed
7. temperature indication
8. error codes (see "
7. Problems & Suggestions
")
9. timer
Fig.1
Fig.2
Fig.3
Fig.4
