Assembly and Operation Manual
9
OPERATION INSTRUCTIONS
Follow the turnstile operation safety requirements (see Clause 7.2).
It is prohibited!
To move through the turnstile passage area any objects with dimensions
exceeding the width of the passageway.
To jerk hit barrier arms, turnstile housing and light indication display so as to
prevent their mechanical deformation.
To disassemble and regulate turnstile components.
To use abrasive or chemically active substances for cleaning of the turnstile
external surfaces.
9.1 Power-up
Follow these steps:
1. Connect the AC power cable (7) of the turnstile power supply (8) to the AC outlet
with the voltage and frequency rating according to the certificate for power supply.
2. Switch on the turnstile power supply. At the set pulse control mode, the turnstile
switches to
«Always locked»
mode. At the set potential control mode, the turnstile
switches to
«Both directions locked»
mode. At the same time the red LED indication
display
of the turnstile cover showing the ban on passage and the indicator above
the
STOP
button on the RC panel (5) light up.
3. Turn on the power supply heating system. When the ambient temperature is below
0°C the heater controller turns on the heating of the internal volume of the turnstile,
and the orange indicator lights up on the LED indication display. When heating is
finished, the controller switches off the heating and the temperature indication turns
off.
4. Check operation of the intrusion detector and siren (if included in the delivery set
and installed accordingly). After the power-up wait until the moment of the test
indicator (inside the intrusion detector) going off (from 10 to 50 sec). Put your hand
before the intrusion detector. The continuous signal will sound when the intrusion
detector activates. To eliminate that sound signal press any button on the RC panel.
The sound will stop without pressing the button in 5 sec.
The turnstile is ready for operation.
9.2 Turnstile operating modes in pulse control mode
See Table 2 for the operating modes set from the RC panel and for the corresponding
indication. Please note the following:
setting the operating modes for each direction is independent, i.e. setting
the operating mode for one direction does not change the operating mode set earlier
for the opposite one;
the “Single passage in the set direction” mode can be changed to the “Always free”
mode for the same direction, or to the “Always locked” mode;
the “Free passage in the set direction” mode can be changed to the “Always locked”
mode only.
At the turnstile power supply switching-on the reset sate of the turnstile is “Closed” (the
mechanical release lock (15) is locked with the key (14) at that).
In the “Single passage in the set direction” mode the turnstile will close automatically after
a person’s passage in the set direction. The turnstile will also close automatically, if the
passage is not made within 5 sec. In the “Bi-directional single passage” mode after the
22
Summary of Contents for TTR-04CW
