PERCo TTR-04CW, Assembly And Operation Manual

Page: 19 / 34

Assembly and Operation Manual
6 MARKING AND PACKAGING
The turnstile has the marking on the turnstile housing in the form of a label located on the
inner panel of the turnstile housing. The label contains manufacturer’s trademark and
contact details, year and month of production, operating voltage and power consumption
of the turnstile.
To get access to the label it is necessary to take off the turnstile cover (2) in the following
way:
1. Unscrew the fixing bolts of the cover using the S10 socket wrench. The fixing bolt of the
cover is located beneath the hub (3), close to the lock (15).
2. carefully lift up the cover with the LED indication display (2) by turning it in direction of
the display. Please pay attention for not to break the inner cables.
3. Disconnect the cable connectors S1 and S2 connecting the cover with turnstile housing.
4. Carefully take off the cover and lay it on a plain and steady ground.
The complete delivery set of the turnstile (Chapter 4.1) is packed in a transportation box,
which keeps it undamaged during the transportation and storage.
Box overall dimensions (length × width × height) ......................................... 114×32×32 cm
Gross weight ...................................................................................................... max. 42 kg
7 SAFETY REQUIREMENTS
7.1 Installation safety requirements
The installation should be only carried out by the qualified personnel after the careful study
of this Manual.
Caution!

All the cables should be connected up when the power supply is switched off
from the AC mains.

Use only the serviceable tools for installation.

Observe general electrical safety rules when laying out the cables.
See certificates of the power supply units for the safety requirements to those power
supply units.
7.2 Operation safety requirements
Observe general electrical safety rules when operating the turnstile.
Do not use!

Do not use the turnstile under conditions that do not comply
with the requirements of Chapter 2 of this Manual.

Do not use the turnstile at supply voltage that does not comply
with the requirements of Chapter 3 of this Manual.
See certificates of the power supply units for the safety requirements to those power
supply units.
18